I have an old Aruba and it works great. The GUI is a bit meh, but considering ive only had to use it once the past like 2 years, owell.

Yup this is the shittiest episode of lost yet.

I want a filament dryer, but I’m too cheap, and don’t use my printer enough. :(

I want to start using it again, but I’ve been struggling to get the motivation to recalibrate and figure out all the optimal settings again.

Or just toss it in the oven at a low temp for an hour or so. I’ve also turn my bed temp up high and put a spool on it with a box over it. Just cut some small holes in the too to allow humid air to come out. After an hour or so should be good to go. Assuming the issue is moist filament.

Jellyfin took a little setup, but it works great for me. Down side is I don’t currently know of a good way to access the media from outside my network. Maybe a RTFM issue I haven’t dealt with yet since I run both.

100% this! Proton pass is convenient, but their email forwarding locks you into their ecosystem, and they limit your aliasing for your own custom domain. I started using it, and its nice, but I wish I knew about annonaddy before. I’d prefer making aliases using a custom domain so if i have to respond with a forwarded alias I can manage a way to reply from it, plus if I ever decide to leave proton, its not a road block. Sure you can usually change email addresses on sites, but may end up being a ton of work depending how many aliases you have, and how annoying the site makes it.

What you think you can just reply to me with reasonable statements I can’t disagree with? How dare you!

Plus the batteries. Batteries are expensive and we need way more that can store more and charge/discharge at faster rates.

Pretty sure that was home assistant. I had the same issue. Phone would even get piping hot. Killed home assistant, problem solved. I’m connected to VPN to home using openvpn 24/7. Too lazy to switch to wireguard :p